Mechanical properties

Whether rubber or hard materials, whether substrate or coating – Fischer has new instruments for testing the mechanical properties of a wide range of samples.

FISCHERSCOPE® ST200: the first scratch tester by Fischer



  • Check the adhesion between thin coatings and the substrate
  • Intuitive user interface
  • Fast measurement

Your advantages

  • This versatile device can be used in coating development, quality assurance and incoming goods inspection
  • The device is easy to use after a short introduction
  • High sample throughput

An accurate analysis of the adhesion properties helps to optimize varnishes and the coating process

New features for high-end measurement with the PICODENTOR® HM500



  • Improved measuring head for the analysis of bulk materials and thin layers in the nanometer range
  • Excellent temperature stability
  • Upgradeable with a heated sample table
  • Dynamic Mode
  • Automated measuring table

Your advantages

  • Accurate long-term measurement
  • Measurement of mechanical properties at various temperatures
  • Measurement of the indentation hardness and the visco-elastic properties of your samples
  • Easy sample preparation for high sample throughput

The precise automated measuring table allows a very fine mapping of the sample

Dynamic Mode for the nanoindentation systems



  • Software upgrade for all modern Fischer nanoindentation systems
  • Testing of visco-elastic properties
  • Dynamic mechanical analysis for small samples

Your advantages

  • Indentation hardness, elastic modulus as well as storage and loss modulus are determined for different penetration depths in one measurement
  • Quick and easy sample preparation

In the Dynamic Mode, the indentor exerts an oscillating force – the response of the sample depends on its visco-elasticity


Available from the second half of 2017

Su contacto con FISCHER

Helmut Fischer S. de R.L. de C.V.
Querétaro, QRO/México

Contactar directamente
Tel.: +52 (442) 260-9295
Formulario de contacto en línea